если какую то часть надо крупнее
сфоткаю
- прячем фото под спойлер | +
?
?
?
?hello.world
efghhhhhhhhhhhhhhhhhhhihhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhjk
Jump!
NAND
1
c
d
e
2
decrypt Jump!5280 wait5280 wait4K&load bbt...??????load env to (addr 0xa0010000, size 64KB)...
page_start=0xf00 page_end=0x1900
?load factory to (addr 0x80100000)...
load bbt...ping_no =0xff
pong_no =0xff
there is no data in ping ,pong buffer
current_factory_start=0x1900
current_factory_start + 0x400=0x1d00
tar end,not found
tar end,not found
default_tv_system=
new default_tv_system=PAL
EPHY: 8211E
check_val=0x0
[HDMI]: Set I2C Speed = 50 kHz
[HDMI]: Chk_HotPlug() TV is not connected.
[HDMI]: Read_EDID abort, HDMI cable plug off.
[HDMI]: TV is not connected.
2nd for PAL
PAL logo
[VFD] init
REALTEK ROM Monitor, Revision KIIE.0402.1067.
Copyright (c) Realtek Semiconductor Corp. - All Rights Reserved.
For a list of available commands, type 'help'.
Compilation time /version= Feb 20 2014 16:19:33 /KIIE.0402.1067
MAC address = 00.ce.39.b5.d7.5c
Processor Company ID/options = 0x01 (MIPS Technologies, Inc.) / 0x00
Processor ID/revision = 0x93 / 0x85
Endianness = Little
Flash memory size = 2 GByte
SDRAM size = 512 MByte
First free SDRAM address = 0x800c5000
Press 'ESC' to Monitor mode
____________________[VFDSTR] LOADING
Set ethernet register: 00000044
NAND Signature(RESCUE__) error! Entering rescue linux...
[VFDSTR] NUPGRADE
Rescue kernel in FLASH, total size = 0x1f52d0
seg.1 addr 0xa0a04b0b, size = 0x1f52d0
seg.2 addr 0x0, size = 0x0
copy rescue0: from a0a04b0b to 81000000, len = 1f52d0
decompressing rescue: from 81000000 to 80100000: size = 1f52d0
Decoding error = 1
lzma finished
М
ЂC В
decompess Rescue using LZMA error!!
defer 625p logo
Realtek>
Users browsing this forum: No registered users and 2 guests